VDC alfa 147

[Matty23p]

Hello guys I wanted to know if anyone of you ? was able to disconnect the controls of stability? that is, VDC ke would be the ESP. Only on alpha mountain VDC, can you? this just using the map?? Thanks to all

[thekid]

To disable everything you need, or remove the fuse of the abs and send him to fail and therefore disables asr abs and vdc. Alternatively I have seen on the 147 safe driving a switch near the hand brake, that should stop a cable under the hand brake about how he is on the point

[Matty23p]

thanks thekid in fact, anke I knew a cos? them under the central tunnel there and the sensor of G we would have to disable that...but kissa if it goes faulty the makkina??

[thekid]

You say in recovery? I don't think even why? x a problem with a wheel sensor, I shot almost 1 month cm all the systems off (asr/abs/vdc) and the machine runs normally

[Matty23p]

you say the recovery marks on the framework the failure of vdc and asr...another guy is telling me that he made x? put a switch and a rel? on a wire in the fuse box, I should spend all...

[thekid]

recovery ? when it cuts power and should not be pi? of tot. By crash abs\vdc\asr will not result in recovery. But you only have the lights lit on the framework

[Matty23p]

sure do turn on the lights on the instrument panel and that's it...now a guy I must give + information, but he has already? did x? he does not togle the G-sensor is always create damage x? from the fuse box with a interrutorre and rel?...now I see ke tells me!

[claudio-abarth]

to me the big point had cut the wire to the black that goes to the yaw sensor on the tunnel near the handbrake lever) and the esp was not available,if you put in a switch ? better cos? the active and inactive at will

[Matty23p]

it is understood, only k on the 147 should not work cos?..for the less than ke, and I know it, they told me to do in another way. Put a switch + rel? on a wire in the fuse box ke basically, when you press the button sends you to the failure of both VDC (ESP) ke ASR and after that it will not work + none of the 2...pu? be??