the problem with electro-guide fiat stilo

[gero]

hi guys, I entered a stilo 1.9 year 2003 with light steering on and steering hard,from the outset the customer to put the car in motion with the cables, and from them and the problem was,I make the diagnosis with autocom and *********** but it's not giving me no error I try with *********** to make a diagnosis on the body but nothing I do alignment proxi and says to me, body and framework tools to configure, I've tried to connect another electro guide but the same problem I checked the fuse all ok what do you think?

[motorsport]

hello ,can? be a coincidence anyway the stylus to this defect in the series of the steering column,controls the power that goes to the ecu of the steering column,then the customer to put the cables backwards??

[blackwolf76]

From diagnosis what gives you on the steering system?? If the light is turned on to force things should give you an error.

[leandro89]

a thing to me ? happened to me, I found that the car did a few laps in the pi? to start because of the battery, replaced light disappeared and light steering. ? a test that you can do with the cables

[giordano_mecc]

Hello ,the problem could be attributed to a failure of the communication with the can-bus network
Have you tried to see in the diagnosis steering if the parameters coming from the can line is correct,e.g. the Speed of the vehicle, etc.
Try to disconnect battery for at least 10min. Then put a good battery and try again.

[gero]

I have already checked power and ground everything in place for the cables I don't know

no error

[carlo abarth]

often ilmodulo steering you care!!!

[gero]

and no errors I tried another electro guide connecting the steering wheel and does not work the same

[todos]

I agree with leandro89 to the fact ch? I ? happened to you too? m? battery problem would result in recovery of the control unit of the steering column, replacing the battery and everything went fine,then I ? happened another stylus with the same problem and it was the alternator!!!!!

[gero]

I connected it to another machine with the cables and not do anything,the alternator charging