Go back to the kind of the ECU according to the number HW?

[Fede78]

Hi, ? can be traced back to that family belongs to a control unit with a certain number of HW?
The ecu ? mounted on a tractor just came out and in the lists of the various interfaces not ? still present.
For? maybe ? a control unit that uses an existing protocol...

The tractor ? a New Holland T5.115 and the number of the HW controller ? 0 281 017 719

Thanks.

[magi1984]

have you tried to look for your number, hw to ******. I usually do so, it was the nose I would say ke ? a edc17.

Now I am with a cell phone and I have no way of search

[Fede78]

I tried but could not bring me anything... ecu tractor c'? a little on the web
With esitronic you can? find some info in the pi??

[angelo]

By Esi EDC17C49

[Fede78]

Thanks for the information! So I guess you have to wait for an update of the current instruments or pu? be with you read and write with a protocol of the current ones?

[munro]

as all the edc17 mounts an eprom tricore...the rooster v2 should read it, write it is on the boot that bdm....I could be wrong??

[angelo]

Quoto munro, limete give us an eyes inside but ? sure tricore

[munro]

edc17c49 ? the same ecu that fits the fiat freemont 2.0 multijet....99 percent sure that it mounts a tricore....

[Fede78]

edc17c49 ? the same ecu that fits the fiat freemont 2.0 multijet....99 percent sure that it mounts a tricore....

Then, according to you, taking a unit type of a freemont, and writing and reading is made in the bdm of one of the tractor I then have a controller cloned from the use by forklift truck to do my tests and not touching the ori?
I read that some units even with different hardware are interchangeable... of course, after having rewritten correctly.

The other thing about the cloning but a EDC16, from esi, you can go back to a controller, which you can find easily and that it can be suitable for the cloning of an ecu, the number of which hw the original ? 0281020057 ?
Thanks.

[giarras]

Then, according to you, taking a unit type of a freemont, and writing and reading is made in the bdm of one of the tractor I then have a controller cloned from the use by forklift truck to do my tests and not touching the ori?
I read that some units even with different hardware are interchangeable... of course, after having rewritten correctly.

The other thing about the cloning but a EDC16, from esi, you can go back to a controller, which you can find easily and that it can be suitable for the cloning of an ecu, the number of which hw the original ? 0281020057 ?
Thanks.

here you go:
http://controlunits.info/partnumbers/bosch/0281020057/