edc 16c39 error p061b calibration centrallina

[marco]

hi everyone, I wanted to ask you a question I'm writing centrallina edc 16c39 with mpps. the writing's all good, when I turn on the car lights malfunction indicator light engine, on the diagnosis results in this error p061b calibration centrallina. the car in question alfa 159 jtdm 16v 150 ps does anyone know why? thanks

[giarras]

and also succeed with that of my daughter, have you tried to delete with the diagnosis..I had to rewrite the ecu again ,if I remember well, I hanche closed the egr in the manual.

[fuorigiri]

I ecu I prefer to do them in the bdm you never know oerdi + time, but you are + quiet

[marco]

hello giarras but you penza that this is a matter of mapping done wrong? and why when I write ori and take them off in the diagnosis error does not turn on + what does it depend on.? ps to the ori. and removed the egr and fap

[frantik3]

rewrite the original, with no change then what you read from the car the first time , clear the error and rewrite the modified , it happens many times on those cars

[msport (exil77grande)]

great information as I've never,however, if it does, even after the council of frantik3 it would be better to see ori and mod.

[magi1984]

? definitely a problem of some modified map in the wrong way. Last week I had a boredom like this with the map of a 156 with the ecu edc16c8. After you have written the mod gave error p1645 contralina defective. I also spoke with msport in private, and I apologize for having forgotten to tell him how I fixed it. The fault was of the map "deal? fuel injected" that I had changed giving too many increments.

As a further test then I used my car as a guinea pig,bmw 120d with the ecu edc16c35, I did the same mod in the same map and in the diagnosis I had the error 4A70: signal map wrong.

[frantik3]

? definitely a problem of some modified map in the wrong way. Last week I had a boredom like this with the map of a 156 with the ecu edc16c8. After you have written the mod gave error p1645 contralina defective. I also spoke with msport in private, and I apologize for having forgotten to tell him how I fixed it. The fault was of the map "deal? fuel injected" that I had changed giving too many increments.

As a further test then I used my car as a guinea pig,bmw 120d with the ecu edc16c35, I did the same mod in the same map and in the diagnosis I had the error 4A70: signal map wrong.

on those ecu edc16c39 that error even if you only raise the limiter a couple times since reading only the area of the data sometimes in the process of closing is not done well the calibration in the ecu and not ? a matter of the map is made bad on those , avr? written a 200 ecu alfa edc16c39 and fiat, and on some it gave the error and I can assure you that an error of calibration of the map is made evil

[magi1984]

perhaps, I am not explained, for the map is made evil does not mean the entire map, only one, such as a torque limiter, just like you say

[cicciogsr]

according to me it happens because? touching on some of the maps are set to a torque that exceeds 500 Nm, and then d? a consistency error