Hello to all,

I tried to read this ECU with Kess V2 via serial port OBD.
Also by varying the Pull-up resistor (to be chosen among the possible present in the setup section) I received the error message, the wake-up.
I've read several conflicting opinions on the ability to read this ecu with Kess V2 via serial...
I would like to understand something more.
I have read that:
- reads quietly
- reads only if the micro is infineon not if siemens
- you read the eprom dissaldandola
- ecu to be done in boot mode or anyway to tour

Someone can give me a hand to see if it really can be read with kess v2 in the serial?

Thanks