The Punto EVO locked while it was not possible to read the serial with kess
Good morning to all, trying to make the serial reading with the kess of a punto evo 85cv euro 5 with start and stop happen to be advertised using the symbol of the padlock and the car does not wish to know... the pump in the tank does not turn and the starter motor's not even as if it were active the immobilizer. in the engine diagnosis I can no longer enter, while in the other systems (with the exception of the drivers). in the body computer, I find the error U0426 that you delete, but after a while, they reappear. The funny thing is that I had just made the ID with the kess and the control unit has been recognised.. then trying to read it nothing, it all went in the block. It is not the first point in euro evo that I read and write via obd in jtag.
After many trials, that of unlocking ecu with kess, I decided to open it and read it on the bench. known that is was already opened by someone, maybe to climb the km.. the pitches of the read have not been touched, maybe they have unsoldered the e2p below. Reading, oddly, has prompted many attempts.. but in the end I managed to do it with the wing nut 53, not even the k-tag has managed to do it. files read, seem to me to be correct. if someone would give us a look..
I attach the file read in the jtag from the vehicle (Micro and e2p) and a Micro found on the internet. Between the file ori read from the vehicle and the one found on the internet there are small differences. I tried to upload the one found, but nothing, not a part of. I did bring the 2 keys and still will not start. in the body computer, the keys are recognized
The data plate of the control unit are:
NEVERTHELESS, 8f2.G4 BC.0103668.B
51896809
NEVERTHELESS.8F2.G4/HW00P/9744-G486
9CR-DM93L
Quote
