solved, I had touched a bit too muchOriginally Written by Danny
also fixed the bit of the rail (bringing it to 250 as mentioned by puntospeed 1.3) and informed the ecu to 1600 bar, but only goes to 1500 ( and I don't understand the why of this), follows p. rail objective but also that it stops at 1500 even if I set to 1600
on the contrary, now that I have reviewed the well logs on the p rail measured I 1480 bar and on the p-rail goal I only have 1450 :O but I climb to 1600 bar! does anyone know why this is?
But that car is
Grande punto 1.3 mjt 75 hp, with ecu mjd6f3hw04p
Since when don't unlock, don't salt the lens, if you unlock it, you must also unblock the measured, otherwise you will turn off
then I will have unlocked only the measured is because it now does not switch offSince when don't unlock, don't salt the lens, if you unlock it, you must also unblock the measured, otherwise you will turn offbut the goal where the unlock? always the bit with index 213 to take 250?
To 1600bar, you need to set 1700bar in map rail. has the offset-100solved, I had touched a bit too much
Ahhhh ok
sorry if I break it, but with what you want to say that the map-rail, ori already has values from 1600 bar? because the one that I found in the higher values is 1604 bar....I was wrong for the case?
you, but auto we talk about..? we were discussing 6jf as well as the file posted backroop, clarifies everything.
Write permission
Quote