another test I think is the one to solder the pin strip directly on the pcb, and power the unit with an external power supply, the same food, the rooster, however, without passing through the rooster the same, I usually do so, then the k-tag, which is more reliable ? all to see , we are always talking about clones not dimentichiamocelo.
ugo ---- president A.E.P.
do as he says Ugoboss feeds the ecu without the use of the cock I use a variable power supply...
so if I understood well I don't have to connect the obd to cock the one with all the wires of all the colors right?so if I understand correctly, the food, the rooster with the normal jack and the control unit of the food from an external power supply without going to the cock, right?tell me if ? so...and then how do I check if the flat ? interrupted, or not?
? always good to use the same power supply with a jack food the cock and then the other output to the control unit, to the flat if you want to try the continuity makes weapons of a multimeter and patience and try to wire to wire.
ugo ---- president A.E.P.
with the jack that I have in the kit, the food, the cock, and with a power supply, the same that I used before I connect it to the ecu, but not to the cock...I think I've got it!the flat I'm already checking...if you even so I throw it to the bucket
the program to work as drivers or folders I have in the folder fgtech?
the gall you have to connect the usb cable to the pc ? the flat cable with the adapter ? just do not need to be supplied, then the control unit the food part, I always like I have done on these units
how not to be fed the cock and as you turn on the led? I'll also try this before throwing it try them all...
the gall you have to be food.
ugo ---- president A.E.P.
but, in fact, I know ugo...I also changed the external power supply for the ecu and nothing to do...the only thing left for me ? solder the pin strip but have to buy them who serve me with a pitch of 1,27...once welded I put the adapter marelli, and if not, the law will not even throw it in the bucket...the ecu is not ? burned-why? is powered when I put 12 volts to the sheet and then get the power but not the law...the only thing these damn needles I try to solder the pin strip if all goes well senn? throw it away...
I in the meantime, I'm following this discussion, I had a doubt...then I took a marelli control unit that I had taken long ago .it is the connected to the counter without any problems with the procedure that I have done, and this I connect the usb cable to your pc then put the flat cable feed: the control unit with a power supply, bench it, I will post..I am in possession of the bdm /ktag even with these I have no problems using the same e xxx...as soon as I can you please post photos
Write permission
Quote
