clutch for alfa 147

[baraldino]

you need the push disk reinforced mechanism to pull, sell them on a well-known buying and selling online, take the kit with clutch and pressure plate reinforced, should go, hoping that once the clutch is the correct socket on the flywheel the same vibrate for too much torque, the flywheel (dual mass)? famous to hold a little higher pairs at 350nm

I'd recommend you step kit monomassa with the above-mentioned clutch, the kit for the coupe tirbo 20v 96 to 98 ? mountable entirely on information relating to the engines jtd/jtdm 8v alfa with a mechanism to pull replacing only the fixing screws of the flywheel, the flywheel if it is well used and the new clutch cost about 250€ full of pressure, and keeps you well the 400nm and 200cv

I have a customer with an alfa 147 1.9 16v 150 bhp with 6 speed gearbox which is mounted a flywheel monomassa with clutch without spring drive to keep hold but ? very noisy and I would be willing to make the change with the flywheel of the coupe to know if you can mount it on this exchange?