give me an opinion on the map 120d edc16c35

[frantik3]

C58D2
try to give max 5%, and see if it still smokes

[magi1984]

however, as you have done the mod, even lifting a hair, it is impossible to smoke,the car is everything ok?
pipes intercooler?
air mass meter?

*msport: yes, everything is ok to ****llo mechanical.smokes only when I am at a high rpm at full load
the smoke ? minimum mind you, doesn't it ? a chimney in my car? however, c? and it bothers me

*frantik: ok I try, for curiosity?, that map would be the one that starts C58D2?

in fettempo I remade the map, by raising the hair of the injection zoned up to 12%, raising the pressure turbo 150punti about and lowering the enrichment and acceleration to 10% maximum

[frantik3]

let's say a correction air-fuel

[magi1984]

I edit everything from 0c58d2 up to 0c5ad4?

[frantik3]

from met? then

[magi1984]

ok thanks, as soon as I try the new map poster? the results
for now, thank you everyone

[magi1984]

then I remade the map by placing injection zoned, turbo pressure and enrichment, acceleration, following your advice.
the car ? improved a lot and although I have increased the values on the injection, I didn't smoke at the exhaust.
I tried changing the map to the address C58D2 as suggested by frantik, the situation had changed, but not by much.
cos? I started with the elaboration of the maps of the injection (ALL) from 1700rpm instead of 1500, while those related to the turbo I left by the 1500's, and the smoke ? completely gone!
tomorrow we'll place the map that I have on the laptop in the company, I forgot to take it home

[msport (exil77grande)]

I would say very good,in fact I didn't understand, how did he smoke it was only a matter of having to fix the injection in a different way.

[magi1984]

here is the last file that was made with which the car is quite good

[mavaila1972]

looking at the map of my car in 2d, I am aware of a curve out of the driver who seems to be very much a limiter rail pressure, much? that is immediately after the pressure limiter rail and its value ? 16000, that is, the value of the pressure limiter rail with the original map.

according to you ? exact my intuition?
you say you change even one as I did with the pressure limiter rail?

this increases across the map only if the map rail pressure your increases exceed 1600 Bar