Good morning,
then, I present a mapping made some time ago by a trainer that the machine in question is my bravo jtd 105.
I would like to understand with you if it is done well or not I'm attaching the map ori and mod and tell you what according to me is not the right way to figure out if I'm understanding some of what I'm learning!
then I list what I think is done wrong in this mapping.
-the limiter rail pressure has been left original.
-the map rail pressure is increased and exceeds the values of the limiter of the press(and according to me this could lead to a block, and/or power-on light engine) and it was edited in my opinion evil with increased values a little without logic
-map the injection partialized was increased only towards the max load and was increased according to me some nonsense
-the maps parzializzate map 1 and 2 were made different, and the increases seem to me to be made a little haphazardly
on map2, there is an increase in the low-load to medium engine rpm of more than 30 which in my opinion is useless and could make the machine scattosa.
among the other off drivers there are other increments that, however, I don't know what they are.
this is what I have seen I now give the word to you and let's see if I'm understanding something, or if I did not understand anything
Quote
