The real terror is the block of the ecu - true or false ?

[carlo abarth]

the edc 15 shooting always if you have a programmer to tour the mountain of the 29f400...etc.. you write without problems!!!

Fuse n?11?
Or did a style on an edc15p and reaching the 15-20% I match the 2?fan
already I trembled in their hands..
I figured in the writing I would have had a heart attack....

[Gianpy80]

Fuse n?11?
Or did a style on an edc15p and reaching the 15-20% I match the 2?fan
already I trembled in their hands..
I figured in the writing I would have had a heart attack....

? for this, each time you read/write a serial port you must attack a booster or a battery charger to the machine, cos? to avoid voltage drop... The audi even in writing to activate the power steering pump electrical...

[savek]

the audi edc15 are the most "dangerous" but read them and write them on the bench no? ? easy you can do also nn disassembling the ecu, remove the connectors of the ecu and there it sticks over the wires to give it +12 , and negative, k line, and it reads and writes, without danger, without removing the fuses and nothing if you want to place the link to the tour

[tuommo89]

the audi edc15 are the most "dangerous" but read them and write them on the bench no? ? easy you can do also nn disassembling the ecu, remove the connectors of the ecu and there it sticks over the wires to give it +12 , and negative, k line, and it reads and writes, without danger, without removing the fuses and nothing if you want to place the link to the tour

it takes the bdm right ? also applies to the golf 4 101cv - 130hp the link ?

[msport (exil77grande)]

it takes the bdm right ? also applies to the golf 4 101cv - 130hp the link ?

in the case of the edc15 that we do not want the bdm, but a programmer eeprom and soldering station/dissaldante but before this, you can try to tour without desoldering.

[tuommo89]

not the sapeevo.....slowly I am learning new things....thanks msport....6 large

[ct46]

According to me you have also forgotten to say that ? very important to the calculation of the checksum, we recall that the interfaces do automatic writing (edc16),instead, for the (edc15) the calculation must be done with special programs such as the ecm is not calculating the checksum, means to block the control unit .

[gfr]

I say mine: never turn off the picture, break the link with the ecu , calm and re-enter you should resume if no......... dead open the ecu, but with official tools

[carlo abarth]

if you want to block, you block with the official tool and the question of seating!!

[legendaryslave]

for the simple reason that you can't change a bit or the whole sequence while the processor accesses to the zone data ? one thing that I never issue tried to do