MARELLI MJET impariamola!

[mariodarkblue]

Hello...you are a minor..but nick strange.. anyway...offset-100 means that the value that you see in the map you need to remove 100bar to have real value

[munro]

before I go any further I would like to reflect on the egr map(so you can dissect all the maps known), and the relative switch-off to disable all the controls and related DTC...
the url 067C4A found "switch" with the decimal value of 14252 to "turn off" everything just bring that value to 47506...
the map the egr is located at the address 067CAC ? a 16x16 in X-axis there are the rpm on the Y axis and the Z I are unknown...

[sportknight]

I can give you an advice? every so often recapitulated all the maps,cos? make no mistake and you will have all the framework of the situazioe an eye..

[leandro89]

Contact Skype cos? like facebook etc you can? trade only in the discussion of buying and selling.

[leandro89]

link deleted
I hope you see good....weight from the post linked from sportnight...

Using the mode? advanced to attach files

[mariodarkblue]

ok, no contact I switch the egr ? correct..as for the "axes" of the map, egr..I don't know them..but I think ke ? enough to switch off

[Backgroop]

So...continuing our examination...then you come to the map ch ECM calls injection zoned map1...that should be rail pressure...
X=rpm
Y=IQ factor cnversione0.002941
z=prail in the bar (note the offset of 100bar)

Now, the map in question ? to the contrary...or that looking at 2d, each curve represents an arc of turns, for example, the last sar? of the 4688 rpm, but the iq of each point on the curve are reversed...this? from iq can be higher to decrease...? interesting to note how the rail pressure, have higher values of 20 bar for 30mm3 that for the next 45...who knows? why?...this I cannot explain...
Now, raising the press rail, it should be raised the limiter...where is????
I know of one in fboost to address 0674be
X=rpm
y=mbar boost
z=prail factor 7.51
the other that I know, and in ftemp to address 067a04
x=rpm
y=temp factor of 0.5 offset of 100
z=prail factor 1

now, there are other maps of limitation?the check bits, where are they?

Guys the map injection zoned as it is called in the ecm ? a map 16x24, ? a map that is called in the real world? main injection as a photo:

IniezParz.jpg

the X-axis indicates the pressure ( rail Pressure engineering and filtered ) measured in Bar conversion factor 2,000000
the y-axis indicates the QI ( also called the map Qmain ) measured in mm3/str conversion factor 0,002930
the Z-axis indicates the time, expressed in us ( microseconds ) without conversion

the arrey of the map ? conversion method ( Pressure rail engineering and filtered , Qmain ) /uS

[munro]

I wanted to buy the tool dvdtuning....

[Backgroop]

photos map main Injection or partial grid and 3D:

IniezParz3D.jpg

IniezParzTb.jpg

[munro]

look carefully at the file backgrop...
the map indicated to be mario ? actually the map rail, and ? a 16x16....
ecm calls iniez zoned map1...
the map times the ecm calls iniez zoned(1) and the one 16X24..