Prova_Win_OLS.rarOriginally Written by SandroMarciano
Here it is!
Prova_Win_OLS.rar
Here it is!
ok, now let's take a break, by tonight, you look at it and move on to the torque limiter.
OK, thanks a lot Sandro.
ok, fine, if you try cos? for? you'll notice a few differences, in the sense that even the q.the. ? limited. Now for the torque limiter.
Always intervenes on the flow of diesel, and then in the map, you can find the values in mm^3/s by multiplying the given value of 0.01, this map serves to limit the torque in detail, why? using the pedal as you can see, you have in a row, 1500rpm, in that immediately after 4500, this would make it impossible for a good calibration. This map needs testing, let's say that usually the maximum ? 70mm^3/s, and you should be able to deliver at least from 2500 up to 3500, before and after go down to to usually the the map play it with winols. this for? not ? among the maps are pre-selected, so you have to look for it in 2d, then put the cursor where c'? the 0 and press and hold "shift" scrorri to the right of 19 points (you see them in the lower left), then you positions where you are in the curve right before the 0 and leaving l? the cursor open the map, and when he says "the x-axis to the top of the from the "eprom - from exup cursor - 16bit lo/hi"
I ? missed a step, select the map, then press the "K", will appear on the left in the list "my maps", then aggiungigli the axis, as I said above.
Not c'? way to do it in 2D via the ECM? I did not understand who knows? that and then with WinOLS I do not know to move.
the first time with winols ? very difficult, but after you realize that ? very simple... however, c'? so also in 2D: have to refer to the curve that precedes the torque limiter, and that is the engine rpm.
http://img407.imageshack.us/img407/9...torecoppia.jpg
limitatore_coppia.jpgThis right?
This right?
limitatore_coppia.jpg
Yep that ? the torque limiter, the first axis with the turns
Write permission
Quote