The exact first clear any errors, then remove the starter motor of the swirl, and see what code comes out. Then it clears the map the corresponding dtc on your ecu is simple knows how to doOriginally Written by MCDJ90
The exact first clear any errors, then remove the starter motor of the swirl, and see what code comes out. Then it clears the map the corresponding dtc on your ecu is simple knows how to do
Perfect, thanks for the tip, then as soon as I can, I try to pull it off, I have no errors from delete at the moment, son-in-law that I sign the code.
Then once you have cleared the dtc, in practice, the drive will not report the malfunction, but will not go even in recovery right? So I can remove it! And at this point, I can't wait to get to the mileage to do the distribution and to change the manifold!
I have not yet tried to see if I can unplug the connector from the top by threading the hand, I hope there is enough space, but I would like to take this opportunity to ask another question, I read that maybe there is a sort of formula that you use to turn off the dtc starting from the error code, but who says that it is not so, and who, instead, specify a specific dividend that is different for each manufacturer of the control unit, can you tell me if it is correct? Thanks again for the info.
A greeting, MCDJ.
There are sw that do this or is there a formula to find the hand of the dtc to reset. And I guarantee you that it works.
I realized that I had made several typing errors, are due to the time and the sleep accumulated, I apologize, hoping that you understand the meaning of what I wanted to say, from a mobile phone does not allow me to edit, perhaps it is not really possible, otherwise I would have corrected the errors.
Still a greeting.
Hi, some time ago I asked for clarification on how to clear the dtc, I have two error codes that I would like to reset, are the P2008 and P2014, if you could apiegarmi how to proceed to identify the right bits to modify so that they can get a better understanding on this also.
See you soon and greetings.
MCDJ90
I tonight, I can tell you the addresses to clear your dtc's, but you have to attach or put a link to your file ori
I have attached in the discussion regarding the swirl these in my file, there is the original one, then there is one currently in the ecu, (which has a strange zoma changed at the end) and then there is what I started to fix, by correcting the final part.
I hope that the link functions, because cell phone is not I did select the file from the box attachments.
Then I await your info, thanks a lot
Good Sunday
MCDJ90
http://www.professionalchiptuning.ne...4&d=1484924082
View 8-bit. Reset 1C8C47 1C8C48
Thanks for the reply, I'll try the same today, so I should be finished with the file, finally.
But you would have a way to get me to understand how to get there? I have read on the forum is a sort of do formula, but change one value (if I'm not mistaken, a dividend) according to the manufacturer.
I would like to learn ������
Write permission
Quote