I can not read the edc15p

[kingsnake]

Last status., V53 tried on golf 101cv edc15p 29f400bt has read and written a little while ago I finished reading a Point 1,3 70cv mjd6 have correctly read the 448kb provided for? I have not tried to write it, to the fury of try, I hope I can figure out if the problem of edc15 ? the hardware or the software, in the meantime, comincer? to change the v53, a quartz 16mhz 2-pin do not forbid lever none.

[msport (exil77grande)]

Do I look like someone who writes rubbish and for pi? only to trigger the counter? If I was cos? hungry for information, I would have written 20 messages per day. I can't stand kids who write with the K, and you admin and moderators you should invite users to write in English.
Greetings

I repeat my invitation to avoid these types of comments,first you do not know the user angelosp while I,second if you don't like how he writes not read his comments, and the third repeat your thinking and' out of place then give us a cut, or are forced to take measures,to the fact of the 20 messages per day, and it you can also write the 80's in a minute, but this does not take away the fact that we control and we put the counter to 0 and then if you continue to ban both directly,for the rest, if you allow for what we need we, the admin and moderators are we to decide and not you when managing your forum from the admin means that you'll call upon someone who writes with the k here we think of the things the series.

[sumi1]

I also cello a, gallo v 84 does not want to read edc15p bench,does it also ecu data...or changed the rezistenze of all types and hef for kline but niente.Secondo me and the firmware inside.

[kingsnake]

It will continue? read with mpps and remove the fuse... C'? but, from how I understood it

[marco_evolution]

I confirm with the pinout you can read and write to a usa one of the gallo 53 even if you have the previous version and go quiet

[sumi1]

with this edc15p bench that or I cock v50 3 led law ok,gallo v50 1 led law ok, gallo v53 law ok,gallo v84 is only pretend that the law and stops at 28, but is the same, even if I do not give 12 volts to the ecu...the relee feel 2 times

[marco_evolution]

Hi sumi, I did not realize what v84 which means pretending? In the end manages to read it or not ? The fw84 not ? always the 3 leds?

[sumi1]

the v84 as they call it, and always v48-51 with 3 led.Il my v84 not even the ecu id stops at 28%, but I don't test just to connect with the ecu because if not i do a 12 volt tour stops at 28%, and this thing is not to logica.Ma, perhaps, and only with my v84 that is so, why does ecu data even in the ecu edc15c7 fiat...this ecu edc15c7 or removed eprom and I can write the law with any programmer to tour(and a ecu tests), Only this is not to be,nothing to do with how long or lost I was the first to throw him a nerd.....

[marco_evolution]

I also share what they call the v50 not ? other than the fw48...you can tell from the list of cars that is cmq ? something very strange I do not use fgtech but I know people that with a fw 48 could not read this edc15p then solved using the pinout that the ec in the new cock that should be 53

[sumi1]

This is the pinout for R/W edc15p


bosch edc15p.jpg