search the web ? you will find the photos how to put in the boot, the ecu...Originally Written by skizzo93
search the web ? you will find the photos how to put in the boot, the ecu...
as required by the regulations and is prohibited.
[IMG]http://bannerbreak*****/banners/3/563/135700419269659378.gif[/IMG]
I had the same problem a long time ago and I wrote with this technique
Boys but I'm thinking if you look at the ecu with ol cock in me.programming 1 in 2000..so the ecu was already written once... so even if you already have programmed a time when I have to open???
[IMG]http://i40.tinypic*****/2mwf9xu.jpg[/IMG]
C'? a little bit of "jelly" in the contacts, proceed with caution.
The boys then unfortunately, you have to open it by force?? Not ? that I would not be able, and only that if you could put in the boot from the connettpre would have been different. ...what the hell's ecu?. ..that's strange that you do not enable the write using the pin set (10)
The guys then??? There no one that can help me??? When I put the pin 10 to+12v and ask the ecu data with the rooster does not change anything...sikkome I'd read somewhere that the log changed perhaps, then, the ecu is not really in the mode of writing??? Maybe the gel does not touch well the needle that I used to send +12v....
you have to put in the boot with a pin to ground inside the ecu as the photo's? no, not the law!!!!!
Open the lid of the ecu and make the boot process indicated above. Cos? you will be able to write without problems.
The boot, which you get by opening the ecu, as I have indicated behind, you recognize why? from the info of the cock to get additional information compared to the standard procedure.
Write permission
Quote