Problem reading edc15c7

[gianni1001]

sorry I add one more thing
of course, the car was attached to a battery charger and the cock v54 I tried to use it with both the power supply and the voltage reading was always of 13.5
with the Kess gave a 12.7.

[ugoboss]

ok, in this case, definitely do not read from a serial to a problem of recognition code, smontala and remove the e2p and then read the counter.

[gianni1001]

thanks Ugoboss
helpful as always!!!!

[gianni1001]

keep this is great, unzip it and use it.

I read it finally in the boot it can be seen from the e2p
the problem is that when I go to correct the checksum with your program and try to rewrite the ecu it gives me checksum error
I always speak of the cock v54...help...

[ugoboss]

if you can mail the file ori and mod them in control, in each case that the program is not wrong, the problem ? elsewhere.

[gianni1001]

Graz ie Ugoboss
Here are the files ori and mod
I await instructions

[gianni1001]

The mod I also tried to open it with the Ecm and save it, but nothing... When I write with galletto I d? always checksum error....

[gianni1001]

Sorry I didn't put the references in HW and sw
846-965
Fiat punto 2001 85cv 1.9 jtd

[cristianbomberos]

Hello to open it with the ECM you mean you have corrected and saved the cks?

[ugoboss]

your file does not have the cks right , try this.