EDC16C - impariamola!

[mariodarkblue]

And..that is not c'? nothing more to say...
really a small little thing...the bit rail..

[mariodarkblue]

Add speech advances....for IQ up to 100mm3, if you do not want to lose time to update bp and do the accounts...can you? safely give an increase of 1.5 degrees by 3000 rpm, then on the last bp dell IQ

[tidus1985]

already limiters-bit rail I never figured out where they are!

[mariodarkblue]

...I have found a couple...x? let's see who post something...here I am spiattellando a lot of info...and something sandro

[SandroMarciano]

maps classic to give the power, which we have described, all of the various limiters, of course, the cheats more? sought not to write them publicly, otherwise what difference would there be for a possible customer to go to a mapper that does the profession and the neighbor who (rightly) has learned on the forums?

[admin]

maps classic to give the power, which we have described, all of the various limiters, of course, the cheats more? sought not to write them publicly, otherwise what difference would there be for a possible customer to go to a mapper that does the profession and the neighbor who (rightly) has learned on the forums?

1? WARNING
Please do not brag to know how to do one thing and then not share it, best to stay silent.

[tidus1985]

now the bits of limitation rail should stop at 1700 bar right, you have to find this value from the map in 2d, and certainly will not be so deviated from the map rail, giustio to apurpose only because I don't see the need to overcome the 1700 bar if not to shorten the life of the pump and the heating of the diesel

[SandroMarciano]

now the bits of limitation rail should stop at 1700 bar right, you have to find this value from the map in 2d, and certainly will not be so deviated from the map rail, giustio to apurpose only because I don't see the need to overcome the 1700 bar if not to shorten the life of the pump and the heating of the diesel

there are 2, one in 1720 and one-to-1750poco first map rail.

1? WARNING
Please do not brag to know how to do one thing and then not share it, best to stay silent.

You're right, I was wrong, but as you see, what I ? been asked I sempref answered all...

[tidus1985]

Thanks sandro, thanks a lot I have a commitment now to look for them

[megamind]

Hi to all, someone's? on edc16 how to eliminate the sensors and any dtc?
For example, if I have a dtc Pxxxx displayed on the picture as I look at the map and then take it off permanently.
There is a kind of research - the identification and elimination total?
An example of car defappizzate c'? the egt2 on the fap that should not serve more? nothing
as you f? to eliminate the sensor and the relevant dtc without the use of a softwere in charge of this operation?

I found this explanation in the network, but not ? I understand a lot (always true)

There is the DTC number table and DTC switch table after that in EDC16.

I know, to turn off a certain Pxxxx code, find it in the DTC number table when it appears first time in the 16-bit hex format.

Formula: (address of Pxxxx code - address of DTC number table beginning)/8. The Result will be the index number.

Then find the beginning DTC switch table which is right after the DTC number table. Switch to 8-bit view.

Formula: address of the beginning of the dtc switch table + index.
Zero address you calculated and Pxxxx code will never appear again

Here it says to look for a 16-bit hex format, once you find c'? a formula that I do not understand what to do?
Can someone explain it to you a practical example?

Thanks