EDC16C - impariamola!

[Errecinque]

Ok but if the stopover is also the axes of the grid becomes deceived the same or remains informed why? I adjusted the BP?

[gianni1001]

Sorry
I found the BP but how do I adjust them..?

[Errecinque]

Sorry
I found the BP but how do I adjust them..?

If I do not say nonsense, the bp of the maps regarding mm3 of diesel fuel values by dividing by 100. So where ori have 7000 (=70 mm3) raise the value of the iq that you want to set.

[jovandj]

If you increase the time and did not update the bp and deceived if you increase the time usually the last or last 2 columns and update the bp then please tell

[jovandj]

Taking a cue from the map of the 2.0 jtdm 170cv I've noticed that at 1500 on the high iq there are delays from 0.49 to about 2gradi....l utility I believe that it is for the turbo spool...someone enlightens me? ?

[SandroMarciano]

pi? the turbo I think the dpf, to keep it in the temperature. That engine uses a turbine that is charged with a breath.

[jovandj]

pi? the turbo I think the dpf, to keep it in the temperature. That engine uses a turbine that is charged with a breath.

You say?? well in fact, and uns real post injection....but if the 1.9 decrease of half a degree of advance should load before I speak only at low rpm with high iq also by smoke

[jovandj]

also because if moddiamo times to the end of the day we go to snooze in addition to decrease considerably the lambda

[SandroMarciano]

A turbo series to load before you just increase the vgt, not c'? need ricorrrere to postiniezioni.

[jacktheripper2]

it depends on how much air you have available and how much you want to smoke more or less 14.5
Lambda with 1200 mg of intake air 80 mm3 of fuel are exactly 14.7....in addition you must also put into consideration the advances that if you to stretch the very l injection times will be longer and you will need to anticipate to a certain point, then you need to replace the injectors or to get them to increase....but up to 90 100 mm3 those of the 1.9 jtdm are acceptable

Wrong, with 1200mg of air you can inject almost 100mm3 with lambda-1. Remember that you need to convert mg in mm3.
The original injectors are good up to over 120mm3, the problem then becomes the length of time you need to make those mm3, in addition to the fuel pump that comes to fruit.