Rail pressure that rises and falls

[nero72]

According to me, and something happened in the mounting of the filter, or of the impurities? in the feeding pipe. As I explained in the previous post, if the port is flush with the gas the car accelerates quite well , if thrust the throttle makes me this defect.

[crteam]

you tell me exactly the car year engine engine type and year?

[nero72]

The machine ? a ford mondeo SW 2008 2.0 tdci 140cv engine qxba ecu sid206 for other info are available. Thanks again to all of you. were better than the one td of a time.

[crteam]

and if you can tell me ke system inieyione mounts if bosch or siemens

this should be without the blower power.make the control of fishing in the reservoir

[nero72]

S? ? a siemens as mentioned above is mounted on a sid206 , then fishing could give you these problems.

[crteam]

If dirty and also controls the red rubber antisvuotamento

[nero72]

Guys, a little while ago I did a check for the dtc on my car ? I found the error b100a, what can be greetings Gianfranco.

[crteam]

But what with the diagnose errors inherent to the injection are p not b

[enzopezzano]

After a diagnosis, you see both the code or dtc, together with the relevant words relating to the error. if you write code as well as also the one that is shown next to you may know you what it refers to. personally, I can't remember a memory of all the dtc.

[tecnoecu]

watch nn I think ke is a problem of dirt perk? at a minimum, the rail pressure ? optimal usually when you have dirt in the fuel, the defects are different es:delay in starting,smoke; hence the discharge, erratic idling,the engine for a bit more noisy, etc...... I think I also that can be a problem relative to the valve attuatrice.