Scodifica Partial Bosch ME7.3.1

[biancanevee]

it seems to me that you did not read my post recall and then I sent an infringement of the official, and it is already the third time that go against the rules at the next you banno permanently then I invite you to read the rules.

sure that you are bad....one not doing it on purpose...and you banned etc. etc .. boooo I don't understand...

I apologize again....are not practical....I can remove the infringement ...hello, thanks

Hello , the interface that you posted is good enough , the boot mode you put in the photo of the control unit with the pin-outs to put the ecu in boot mode you need to ground the pin 20 for a few seconds before entering the picture after it detached from the mass and the beginning of the reading of the flash.

and can do it without the boot mode?

[msport (exil77grande)]

if you do not understand the problem and your on to the next bullshit you're out.

[biancanevee]

can you explain to me where I'm wrong? I did not do it on purpose...let me understand

[ecutano]

sure that you are bad....one not doing it on purpose...and you banned etc. etc .. boooo I don't understand...

I apologize again....are not practical....I can remove the infringement ...hello, thanks



and can do it without the boot mode?

But what a problem you have to put a wire to ground , I begin to think that you only want to increase your posts , true !!
If you need a hand you do willingly , otherwise let it go !!
Hello

[biancanevee]

then the problem ? that he is never done...and then the photo you sent me I can't view since I can't download anything. how do I put the wire to ground if c'? the connector attached?

[ecutano]

then the problem ? that he is never done...and then the photo you sent me I can't view since I can't download anything. how do I put the wire to ground if c'? the connector attached?

The connection of the control unit has the pin out is numbered , the pin 20 will not the avr? no wire , insert a needle attached to a wire that matterai to mass

[biancanevee]

sorry maybe I am that I am that I am ignorant on the subject....sorry but if c'? the connector above as I put the needle? and then the pin 20 to which of the two connectors? we admit that it is able to ground the pin 20...after? the other connector should be plugged in while I do it?

[tronic]

mamma mia, what a drama

[biancanevee]

then someone explains me better...the needle and I have to tuck the side of the connector, right? or lod evo rest on the pin 20 from the ecu...I do not understand....then I do not understand a ltra what....if I was there I put the pin in the connector, of course, and off...then when I have to hang up?

[motorsport]

the pin I have to stick by the party?? leave that to slip us which is better hahahahaha....then I do not understand another thing....if I was there I put the pin in the connector, of course, and off...then when I have to hang up? you have to attack after the holidays hahahahah

joke, you should have been explained more? times, and nn you know, then you have to have pi? or less than 10 individual wires and connect them on the pins one by one,c'? written all over it in the pdf with the figures and demonstrations, you will also find the numbers in the connector where to connect them, you can't go wrong!!