first map bmw edc16

[E92_mpower]

and the mod address 0D7644 mod.jpg

[munro]

I can't see the image but it seems to me that you have changed all over the map, including aces... according to me cos? not good....you should start moddare from where you have moddato DW and TL...then I s? ch you are still missing the maps lambda...
if moddi,adjusting to the DW,10 maps of limitation... but leave only a ori your iq(injection quantity) sar? always castrated from that only limiter....

[magi1984]

that is, the first "2 teeth" are the axes, and those must be original
also, you should start to change from where you've changed the other maps, as it says munro.
the cio? if you have begun modifying at 1500rpm, you have to start from the "5 tooth" to change.

so in summary let the original the first 2 curves that are the axes, and the next 4 curves that are the rom to has been of the 1500giri.
if you've started to change since 50% of the load in the other maps, even here do too by changing from the middle of the curve up to the end

? pi? easy to do it than to explain it

[E92_mpower]

ok but the fundamental problem ? that I from 2d I don't know where to look to figure out what rpm and at what load
I make a screen please?

[magi1984]

just look how you've changed the maps of enrichment and acceleration in 2d to figure out how to change that

[E92_mpower]

you're telling me that I have to select the same number of "gobbette" call them so? and that start and end at the same point as those of the map DW with clearly the same increase.
However, I realized it only remains for me to try... some place the image of the 2d

[magi1984]

you have to select as you said, exact? not with the same increase why? these are two different maps, in the map nm on iq, you can be between 5 and 10% increase

[E92_mpower]

thanks for the important tips that are giving me now I have no way to apply the changes to just do the whole place

[E92_mpower]

there we are
then I left the first 6 gobbette stock as said and incremetato the other 5%
starting from the 1500giri in then I put the photo of the 2D one ? to see the starting point of the other to see all the parts increase

address 0D7644 mod correct 5%.jpgaddress 0D7644 mod corretto.jpg

[munro]

still no go well..according to me....zoom the map with the ecm and controls better..the first two curves are still moddate even with increases in negative....