I try upa

[albertoS4]

perhaps you will do attention to the connections to do, you may need to lift some pins (I'm not sure) but, I don't think you'll have problems with this type of uC

[isfedale82]

the 908 is always a NXP (former freescale, former motorola) 8-bit... is the law according to me to secure safely

the other most common scodifiche they are quite? the full version with the schedule coast however, not eralsoft

[albertoS4]

I've used it on hc912 to clone the EEprom, I rpovato all the micro that the upa supports clearly....

[albertoS4]

in regard to the schedule, as I said in some previous post, you should attrezzarti with a nice kit of crocodiles/ pinzettine to draw the pins from the micro.
I usually prefer to use the crocodiles and solder a soft cable on the different pin of the micro to get to the crocodiles

[albertoS4]

I am fine as well... also because often the read errors are also due to the contacts not just perfect between the upa and micro

[isfedale82]

I've used it on hc912 to clone the EEprom, I rpovato all the micro that the upa supports clearly....

the obvious one....maybe you have tried something that does

[albertoS4]

you need to a single thing, or we often work with these facilities?

[albertoS4]

I have nothing nn working right now with the upa, I have read the ATMEL, MICRICHIP PIC and EEPROM standalone

[albertoS4]

when was not or cie was to lift the pin from the pitches of the pc or I connected bad I

[isfedale82]

you need to a single thing, or we often work with these facilities?

for now, a one-time....