kess v2 clone boot mode help!\

[silven]

On Saturday to try it I made one just with the kess, usually in the boot to do with the cock kess me feel better via the serial..***** s, I used the module in Bootloader and cable 14P600KT02 in the diagram and power the module, everything is ok, read and written without problems, check the resistors as I have already? said, long time ago with a other ecu I couldn't put it in the boot and had a resistance that was 120ohm and not communicated,and then if you haven't done it we would have to make the change of the diode to the kess for him to "digest" almost all

[fabiovts88]

Nothing I tried again today on another ecu bosch always me 7.9.10 but nothing tells me to wait for a couple of minutes and then nn is nothing

[silven]

And then I know that ? your interface has some problem... as a last resort if you haven't, try doing the edit of the "diode" to kess.

[robo]

The tricore modules of the Kess china does not all go as they should, while the Kess euro tested and it goes like gold.

[fabiovts88]

you say that the diode will act?? now I'm purchasing the ktag maybe with that I can see ? or not ?

[silven]

The change of the diode is the only thing that you can? do ? improve the interface and then try does not cost you anything... my clone before the change were more? the ecu that was not that the things that were going... then I tried with the edit, and I do not have more? had false alarms. If the ktag ? good... you to solve the problem, I however, this is a unit I made in the boot even with the gallov54 without problem. I'll include the change in case you want to try,I recommend mounting the diode as shown in the photo is as to what kind of that? 1N4148 diodo.jpg