I tried it, but from the standard values as if it were empty.
When I get home I try to desolder and read.
With regard to cq I automatically eprom (recognize it), and then it should be working Right?
I tried it, but from the standard values as if it were empty.
When I get home I try to desolder and read.
With regard to cq I automatically eprom (recognize it), and then it should be working Right?
I too have the cq 4 but I always have to select the type of eproom does not make me the automatic research perhaps will have? select qlche setting to me ? happened to me also that in some eproom it's me doing the verification and qndo the reread ? ori's writing is not without experience in that case, try to make it to the tour
Thanks claus to the speech of the type of eproom was in doubt because in my case there are various types and are not able to figure out if that worked right the ecu mounts 95160 but cq 4 has a variation m951660 + others that I cannot recall now as they are still at work.
where the symbols preceding the number should be the manufacturer of the eproom the same and I don't know if it has an influence in the encoding.
However appenatorno at home I make a further proof also because this morning it was early when I wake up and maybe...... I was not at 100%
Thanks
eproom 95160 ST code cq 4 ? m 95160 corresponding to ST further writing but verification failed, now try? desolder and hope for the best
dissaldala and put it on the adapter weld-on, remember that many of these in addition welded under a bit of glue that keep them attached to the pcb, I use the morning with the dissaldatore air after that I removed the pond, so it softens the glue and comes off well.
ugo ---- president A.E.P.
ok thanks for the tip
as soon as I can I try and let you know.
The problem ? the job takes me a lot of (luckily) and the car and stop by the Christmas holidays
yesterday I did the first test on the car (200 km round trip) and I would not like to do more travel in a vacuum.
further update welded the eproom but and the same result
" and"Writing Code Memory...
Elapsed time: 9.07 Seconds.
Writing device COMPLETED OK
Control ID: MISSED
Verification Code Memory...
Verify FAILED, Address=0x000000, Device=0xFF Buffer=0x02
Verify FAILED
Time elapsed: 3.45 Seconds."
at this point I don't know what to do
[QUOTE=Verify FAILED, Address=0x000000, Device=0xFF Buffer=0x02[/QUOTE]
With regard to non-verification, I realized that the eproom ? divided into three sectors, one of which is locked and not unlockable which is 0x02 exactly what is charged.
now how do I know if write ok
none I can? or wants to help me?
and can replace the eproom with an equivalent rewritable?
Write permission
Quote
