I have repaired several and so far no problem.
and advisable to change the whole kit easily available for you ? affixed....
I have repaired several and so far no problem.
and advisable to change the whole kit easily available for you ? affixed....
Ok if you can wait that we dance for the cock see PM if anything it makes the tt together
ok leave me your contact in pm or call me at my.Originally Written by angel
[IMG]http://bannerbreak*****/banners/3/563/135700419269659378.gif[/IMG]
anyway the place and again with the mod and info in + July 2012 pw in pm!!
You do not really understand something until you can explain it to your grandmother (Einstein)
hello Motorsport, since I can not contact you in private, could you give me the password to your guide?
Thanks
I have repaired a discrete n?,nel99% of the cases ? the mosfet and the fusibbile smd, then I do the carpet the welds near the 8pin smd are, from the connector ,an important perfectly clean the board after soldering,the dough is contained in the tin for solder causes defects of the shutdown,the first time that I have not cared for the process of cleaning it I lost 2 days trying to a defect which was basically solved.
? ache important after repair, make holes with the drill on the body of the plastic x improve cooling and prevent breakage in the future
Thanks x the answers
you have to heat it with a hair dryer-hot air what type of car designers welds behind the shed of the display, or belittling
Also I have repaired one with success.
Before I changed the mosfet with a IRFS4127 that has quality? the upper (20mOhm, 200V) then I soldered in parallel to the suppressor current (resistance) white another 1.5 To, just to be on the safe side. But by measuring the components, I found that they were healthy. Of course, reconnecting the framework was working at times then you spengieva by moving it or by light pressure on the connector. Were the resistors from 1 ohm that you were dissaldate, remodeling and distributed to the great.
Work in a factory of electronic cards and I can tell you that it is a widespread problem. And since when have prohibited the use of lead for welding and began the odyssey electronics malfunctioning. And really almost impossible to make the welds good , without burning everything. In addition, and also a lot more difficult to do the repairs... in theory it should be scaltare of about ten degrees in.... in practice, sometimes the card begins to smoke and still the welding does not yield.
A conspiracy nice and its on the pretext eco-friendly to produce the most garbage, instead of making products that last.
Write permission
Quote