KESS V2 MY works 100%

[ecuprom]

The v2 24v kess pu? work without any problem. With this change you will see? that the K-line diagnosis works perfectly.

[mafani]

The v2 24v kess pu? work without any problem. With this change you will see? that the K-line diagnosis works perfectly.

ecuprom I did not understand ,with this change, the v2 clone can also work on 24v? or only the original works at 24v?

[ecuprom]

If you look at the power tab kess pu? support up to 30v, but ? fully protected subsided to work after the meal, that ? 5V board microcontroller, as an entire work.

[ecuprom]

I only hope that I thank you.
Tested with MED17 TRICORE with adapter Tricore.

[mafani]

thanks ecuprom as soon as possible we will try this mod

[ugoboss]

thanks, even if I still don't have the kess, now we are waiting someone doing the edit and test.

[ecuprom]

I hope that help your Kess v2 to operate the line K.
This pi? that tested and it works. The line value 12v K works with the protocol below.
-70% Of the supply voltage for the data to be sent.
-30% Of the voltage for the data received.

[ecuprom]

? can work without problems with 24v.
But if you have not enabled protocols truck, that the use 24v?

[ake85]

? can work without problems with 24v.
But if you have not enabled protocols truck, that the use 24v?

if I understand correctly ecuprom this change is just to read the protocols of the truck as line 24 volt? or I am mistaken? thanks

[ecuprom]

Photos of the line integrated load KL and Can Bus