Sorry how do I do this?? Why? where were the codes and cleared it only reads 033 but I have the numbers hw and sw..I don't think even ke maybe it can be a me 7.3.1 why? the pc me the questions well with 1.5.5 .
HW 0261206061
SW 1037350386
Thanks for your help....
if the car of 1998 and with the hardware you can? only be m1.5.5
Paste exactly there? that read by querying the ECU with Galletto.Originally Written by skizzo93
If something ? gone wrong in the writing, yes ? locked.
Ninth, the rooster mark all good anke after the error and the gtv works perfectly, why? l error gave him before the cancellation.... the fact and ke, I put the pin 10 to 12v ( is there a way to know if the ecu is in the boot before writing??) Continuii i.e. not under the framework for? as said, it's not gone, and the cock said to me (before starting) to put the pin 8 to the positive......I'm not in the heads more than anything
The pin 10 of the connector on the ecu, it should not have the wires connected to the car controls it well...
The patience and virtue of the strong..
No No no c and no wires attached....I with a needle to which I soldered a wire or put the pin 10 of the connector directly on the positive of the battery and then I turned on ik framework...that is, the procedure and the right...only problem and the error seedkey and strange thing, and the cock that speaks to make positive the pin 8....maybe the positive on pin 10 must be under the framework so as to give a positive on the pin with the ignition ecu???
must not be under the framework... by 12v and you keep it so until the close of the ecu... so I did it myself on a 156 1.8 TS ME 1.5.5.
Then I did well...then perhaps the error was given because? maybe l needle did not touch on the pin even if it seems strange to me....
Make sure you've got the right pin. Below is the pinout:
external links are forbidden, the next time you add an infringement of the official
Last edited by msport (exil77grande); 28-01-2014 to 00:02
Sisi perfectly what I have taken. ...at this point the only explanation, and that did not touch the pin on the pin... putting it in the boot, to be sure before writing lights that I know the written code (type the me 7h4) or perhaps by querying the ecu with the cock appears to be something that makes you understand that it is in the boot??? Anyway, thank you everyone
Write permission
Quote