yes, but the mechanic told me that it is not certain that then work really.....!!I tried to ask you why? maybe someone of you had already? the fact I'm working and had to jinx tested if the airbags work.. I try.... we hope
yes, but the mechanic told me that it is not certain that then work really.....!!I tried to ask you why? maybe someone of you had already? the fact I'm working and had to jinx tested if the airbags work.. I try.... we hope
in the dry or in the wet, curved like a damn.....:cool:
reading around, precisely, put a resistor..
c'? a procedure for the installation... with this simulerebbe the presence airbags for every seat...
as you say the dealer that sells the seats sabel provides the resistor together.
as I have described above, the lamp goes out, and everything works...
even if I am opposed to eliminating these devices for the simple fact that in the event of an accident may not pay the insurance
why? tampered with a safety device... saw that the car was equipped...
on the stylus, for example, just reprogram the eeprom of the airbag control unit with a small change to the software turns off the light by mistake passenger...
you ma ? different situation, what ? the employment passenger seat, another ? remove the drivers side seat
I would like to just remove.....
in the dry or in the wet, curved like a damn.....:cool:
this I understand...in fact, I have said that I put the resistance 2.2ohm 1/4 of a watt and you will see that there will be problems.
light is off and drivers operating in the event of an accident
ok, thanks a lot for the help..Originally Written by magi1984
in the dry or in the wet, curved like a damn.....:cool:
I confirm that I work
Buenas..., para simular a drivers, the resistencia generally, debe de estar entre 2 y 5 ohmios, yo utilizo 3,3 ohmios (for example, a value of m?s equilibrado). With esto lo que se consigue es enga?ar to the centrality, para que no entre en mode damage y siga manteniendo el operating system.
Para sensor de ocupante es distinguished, este system lleva a m?dulo que transmite por c?digo cifrado (K-line) hacia la centralita de drivers. Place it so not just with poner a resistencia es diferente para cada modelo. (bmw, mercedes, Fiat stilo...por ejemplos)
.
ITALIAN ****** traductore:
Good ..., to simulate an airbag, the resistance in general should be between 2 and 5 ohms to 3.3 ohms that I use (it is a value of pi? well-balanced). This ? there? that you get ? fool the ecu, so that is not the mode? failure and continue to keep the system operating.
For the sensor of presence ? different, this system has a module that transmits the encoded code (K-line) to the airbag control unit. So don't just put up a resistance ? different for each model. (BMW, Mercedes, Fiat Stilo ... for examples)
Greetings
Write permission
Quote