Read peugeot 206 plus 1.4 HDI

[passione motori]

Hello all, I have a doubt comes to the reading and writing of the machine to a customer, ua peugeot 206 plus 1.4 hdi, the car in question is supposed to mount a bosch edc16 while stanamente I can do the data only with the driver of siemens six80x of the citroen and peugeot driver I do not read either the data, hw and sw 9660300280_9653451880 bed with protocol 29f400 PSOP ecu Siemens cirtoen 1.4d sid 80x, data that is read with kess clone (V1)

May the mountains this ECU?

the file ori already taken here on the forum, but can you confirm that ? can find this ecu on this car?

thanks in advance

Hello, Siemens SID 806 5WS40285C T these cars ? better to make a BDM in serial give a lot of problems, and often you have to place them with the Lexia encoding and other.....

[CorsaroKr]

I appended, would affect so much to me to have clarification on the rolling code...
time ago I read the ori of a ford fiesta 1.4 tdci 68cv 2007 (sid804) and I prepared the mod.
Now I understand: I can load the mod with no problems? a month has passed since the reading of the file ori)?
If one day I want to go back to the map ori, I can upload the file without any problems or do I have to re-read the mod and return to the read file to the ori?

ps. use the clone galletto 2 v50

[CorsaroKr]

Hi, at a distance of time I write in the hope of being able to be of help to someone... with the galletto 2 I have written more? times on the ford fiesta (with both ecu sid 802, and both with sid 804), and I never had problems with rolling code.
On the sid804 I also tried to upload the file golds at a distance of one month from the loading of the mod and no problem.
Apparently, the problem of the rolling code only for the reads/writes done in the boot (in that case ? need to pay attention), while for reads/writes from the obd, the problem (at least with the wing and with the kess v2) does not exist