Dpf/egr opel meriva

[oakley1]

But which file you have selected? You have to write the flash cut to a mega

[MOT]

I found the file 2mb cut with ecm ,I tried to just delete the egr with carsoftware ,and I tried to write and gives me the following error ...
I checked the file is from 1mb dov? the problem?

[oakley1]

But this Opel of that year ? and how much hp it has?

[MOT]

I showed the data, hw and sw, however,
? an opel meriva 2006 1.3 cdti 75hp

[oakley1]

... I Know that the Opel in serial with the mpps do not write.. If controls 1.3 mjet minsa that c'? only the 70cv .... You have to go to bdm

[MOT]

Now I'm re-reading the file,I thought I'd try to write in the slow after
Excuse the ignorance if not did you why? I read in the file?

[oakley1]

Wait why? I wrapped... You this file you read from the obd or have you found a network backup?

[MOT]

the backups on the network, why? I had read a file from 118kb that even the ecm was reading and I thought that was like the mjt, which we had to find the file on the network then cut it and change it...

[oakley1]

The file that reads not ? good.... If you ever did make ECU data and you have found the file or... ? here we are... It was the 70 horses with the mpps were writing to, but the 75 and the 90 Opel .. Then only bdm or an interface that will allow you to write it

[MOT]

ok,That's bad luck also this to me ? went bad...but for curiosity? even MPPS V12 the law?

There are guides on how to read it in the bdm?

Thanks anyway for the attention