ok thanks so much sandro , as soon as I fit the machine I try to install this, then for veedere what causes me the problem.
a question, but then you can only disattivcare only the dtc of luca stanca and just? you will have to disable them all?
accenderebbero light engine, all of these of luca stanca, or remain only as errors?
in theory it would be ideal to disable only the dtc of luca stanca, but since you should know exactly the bits, and the method with which they are distruibuiti programs disable the entire area... I don't do mainly luca stanca, so I don't there are never dedicated, but I know that ? can find them even without going to trial!Originally Written by michele30
p.s. the map does not contain errors such as to create damage... no ? all this great map, but the problems are not to be charged for it.
If you have disabled all the management of the "errors" you'll want to of course re-enable it as told by colleagues, otherwise it will be very difficult to get a diagnosis.
We WILL add a suggestion (take it with the springs....) : are you sure of the efficiency of the diesel filter and the user does not use fuel of poor quality? ?
A friend of mine that I had made a mappetta each had of the blocks, without a real recovery. The machine crashed, it went up to 2000 rpm and the like.
'd blame the FAP and the change instead ? shown that it was the filter completely "locked" crap, used to distributors for low-cost with diesel bad. Only replaced that piece, changed the distributor and the car ? pi? a year that runs without any problem...
michele.. but have you done the test, disconnect the pipe absolute pressure sensor? goes equally in the recovery?
I'm sorry, david , the machine does not ? in the workshop the customer is using it why? the need and this defect ? sporadic, so it can happen tomorrow as between a month
I was gathering info as possible so just is the machine I do a few mods.
ok..trusted that the recoveri ... without lights after the luca stanca... and...!! the maximum injection times... but the map unfortunately, I can't see her... 'll be waiting
Write permission
Quote