Lancia Lybra 1.9 jtd Ecu Locked Aiutooo

[Makx]

I forgot to attach the photo although I don't think is necessary.
it aprofitto to ask what the other programmer eeprom I could get, if the cockerel V54 wasn't suitable... I gave it a look but it seems to me that the Programmer willem G-Q4X is suitable for a chip with a max of 40 pins while the flash of the edc15c7 has 46

not I attach photos of the ecu, because is known that is covered by copyright, and I know that would be a problem.
however, it is certainly the ecu that I have said that I think you know already well how it is composed.

[ugoboss]

the e2prom on your is from the part below, from the side opposite of where the ec on the flash, read and write your flash is a G-Q4X but it takes the adapter, the rooster will not you need to read the e2prom, it should be welded, and read always with the G-Q4X with another adapter.

[Makx]

Thanks ugoboss,
for the accuracy, can you tell me if the one circled in green, red or yellow in the attached picture.

[lui93]

to me it is the same thing happened to ugo boss with a 147 , I had to do what he said above hugo boss after attempting to write the file ori to make the forced and nothing the same.

[Makx]

I probably wrongly interpreted "The side opposite the flash," you mean that cans just below the flash on the other side of the sccheda (the one in this picture I circled in blue?)

lui93, have you tried writing a serial with the e2p removed?

[ugoboss]

I had taken one with those rims, is that to the right a little more in the bottom of the green one in the first photo.

[ugoboss]

is an eeprom marked 95P08 that must be replaced with a 95080.

[ugoboss]

is an eeprom marked 95P08 that must be replaced with a 95080.

sorry I wrong to write, it must be replaced if you need to reschedule, but if you only have to unsolder and then resolder it is fine for that.

[Makx]

Then Hague... I should have circled the right one now (please enclose)

I say aia because it is virtually unreadable the code fatigue read ....08C3
so in short... I have the strong fear that is burned this component...

unfortunately, I still have not found anyone who feels able to work on solder of this type.. tomorrow I attempts in two other places, the ones I have heard up to now insist that serves the station with compressed air.

but if as I fear the problem is the chip burned?

[Makx]

sorry as usual I had no attachment.

I would put a photo where you can see better the aesthetic conditions of the chip but I can take pictures so detailed, unfortunately.

if it was burned really like I notice it?
and in that case that solutions do I have?

but it could have burned just by having loaded the file .mod of the first page??

it seems to me absurd...