cloning sid 804

[tecnoecu]

is in diagnosis enters

[amen]

And what errors do you have?

[tecnoecu]

hello excuse me then, I correct in the diagnosis, I told my collaborator enters into the body no, but in ecu engine

[amen]

Then you agree with me that there is some physical problem, the welds ok?

[sportknight]

I know that this ecu is cooked...

[tecnoecu]

hi then will update on the situation.I found another ecu with the same number of hw and sw before you put the hand I tried to see if he entered the diagnosis and it was ok after I disassembled it I cloned the eeprom, and replaced the flash with its original horsemanship all and nn part nn even part of the diagnosis, I put back everything as you first enter the diagnosis, but logically, the nn part.what would you recommend for me?

[amen]

Then you understand that the flash is damaged

[danyparis]

Hello ,
ECU SID802 , 804 and 806 are identical .
To clone must change the Flash and EEPROM.
Are already several times)

( Sorry if I make mistakes, because I use a translator I am French )

[tecnoecu]

no the flasks nn is ruined because if the mount on the control unit original of the machine part, I think that me this ecu to be cloned, perhaps it also takes the reading of the micro

[danyparis]

Can't read this micro ECU because no BDM