Alfa mito 1.4 78 hp-2011, engine type 955A1000

[giaxi]

programmers there are many, some, a little, and others are all, one of the best compromise I believe that it is the GQ-X4 of the MCUmall Electronics, the program checks to see if the 3.2 the working file.

Thanks, in fact I was focused on GQ or on the UPA and with regard to the 3.2 seems to you, but I'm not sure

[giaxi]

programmers there are many, some, a little, and others are all, one of the best compromise I believe that it is the GQ-X4 of the MCUmall Electronics, the program checks to see if the 3.2 the working file.

I chose cq-x4 why? it's as you say ? one of the tradeoffs the best and, above all, why? I found it near the house and I can pick it up in person then ? available immediately and for immo 3.2 is the eprom (rivergina only).
Thanks for the advice I do? know the end result.

[giaxi]

Unit just arrived BOSCH 0261 S04 407 51854161F if anyone can help me figure out if ? the right one for the car in question, I would be really grateful to you, and if maybe there was a chance? update to 95cv.
Unfortunately, I still don't have the history to be able to read the file ori and I don't know how to proceed.
Thanks

[ugoboss]

if placed in the V. I. N. of the car, you can go back to the number of categorical exact.

[claus]

if you have difficulty? desolder the e2p,you can also take the tweezers soic 8 to read it without desoldering ,since you have taken the cq4 you give the adapter

[giaxi]

if you have difficulty? desolder the e2p,you can also take the tweezers soic 8 to read it without desoldering ,since you have taken the cq4 you give the adapter

Exact came the caliper soic 8 and written to the e2prom, only that I have a doubt, writing is giving me error also occurs if write ok, I think due to non-possibility? read the e2prom, a doubt solved with the installation and test on the car.
in short, I think today pom provo
Thanks

[ugoboss]

the only one ? try if it goes on the bike, in any case, I always prefer to desolder and make it to the tour.

[giaxi]

unfortunately, the test negative light on immobilizer.
The good thing for you ? the ecu is ? ok to all the error codes the car is stored have been resolved, the negative thing ? the car is 100 km away from me, and I'm in trouble for the tests.
I don't understand if you adjust that I can not do the check writing?
Who I can meet each of the council ? well I agree.
Thanks.

[giaxi]

I don't understand if you adjust that I can not do the check writing?
Who I can meet each of the council ? well I agree.
Thanks.

I did not understand whether it IS regular that I can not do the verification OF writing?
Who I can meet each of the council ? well I agree.

[ugoboss]

the verification of the writing at the end the should do, I speak to you, however, always write to the bench with the e2prom welded, if it does not, can the welfare that you were wrong to select the memory, but I repeat to you by reading it and writing it on does not give me confidence, have you tried to read it again after you have written to see if the law that is the same.