yes, I wrote above that' encoding' in place...Originally Written by rodcraft86
yes, I wrote above that' encoding' in place...
have you checked if the chassis number ? to the place.
ugo ---- president A.E.P.
I tried to change the sensor rail pressure that I had a spare but the error and the behavior is the same...
Now I have to see with the regulator pump because I understood that the rail pressure too high and leaving open a screw on the rail, which was the naphtha until controlavo ignietori you abbasava the pressure in the rail and the machine worked much better, almost like the are.
It will be the pressure regulator, as mentioned above in the blackwolf76 and rego88, everything I said yes, now let's see...
everything in its place' here...
Forgive all the golds and see what the f?..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
I put the ori and the situazzione and equal, as written above...
In the meantime, I have removed the pressure regulator and I have found a bit of resin metalica, sara, perhaps from the pump.
Tomorrow I get the new regulator and then,' let's see...
Make sure of the provenance of the metal efore us the new controller, and if ? the pump may also break the injectors
the car has the speed limiter? in the map, and not in eeprom2 I would not like that you have changed something and went to change something in eeprom2 and now you back the most? to****
the best thing about those cars and get her in the bdm as said in previous post rego88
!!!
Hmmm... On a trafic in this way, I've disabled the limiter at 100km, which is in the e2p and everything went ok.
Vivaro 1bit No Limiter.jpg
I know that it can't see the pictures, here is a zipped...
Quote
