problem mito 1.3 multijet

[francescosparco]

In this case.. there prover? . I really want to learn

[rodcraft86]

? a sort of virtual reading, it works so well?
the rooster has some file ori in the database of the software, when you go to identify and then read a marelli m6 or m8 he recognizes the ecu, and extracts from the database the corresponding file, the thing works in the first place if the rooster ? good workmanship and in the second place, if the file ori corresponding to the ecu ? in the database, basically it works as if it were a normal reading from serial port but it takes very little, the green progress bar is moving forward quickly and in the end save the file that is extracted

[francescosparco]

Sin to me, nn, and went

[ugoboss]

the virtual reading takes place on those ecu where not ? can do the reading from the obd, in that case, if the file ? in the database of the tool is the virtual read, but if you look at when selecting the car you say.

[rodcraft86]

exact, ugo has the right, at the bottom above the progress bar, it tells you if you make the virtual read

[francescosparco]

Nnt to me nn ago

[rodcraft86]

then either you don't have the file in memory, or it does not, the virtual read, but I think it is pi? likely the first hypothesis

[ugoboss]

then either you don't have the file in memory, or it does not, the virtual read, but I think it is pi? likely the first hypothesis

to me ? happened a couple of times that I had the file in memory and told me to open it and read it in the jtag (were 8df) and then send the file to them, very likely for an update of the database.

p.s. I have the v53 clone.

[francescosparco]

I v50 clone

[rodcraft86]

I have the v54 clone and now I always read all of the m8 in virtual, for the m6, I have found that not c'?ra in the database, but we thought the kess v2