the you can? test also so....Originally Written by xathanatosx
to vary the pressure varies the voltage...
searched the web for the datasheets and see how much pressure, how much output voltage from the map corresponds..
or if you have ******** the sw tells you all the procedures for diagnosis...
A rider does not create queues even in the car...
a automoblista create queues even on a motorcycle...
no nothing ********use multiecuscan but according to me, distort seen that if the sti sensors bust the ecu no errors. at least I think....am I wrong?
hello.. how do you test the mass air flow sensor if it works??
you look at the values of the voltage on the maf....the minimum should be about 1.5 volts....with the machine all accelerated should give around you have 4.5 volts...
A rider does not create queues even in the car...
a automoblista create queues even on a motorcycle...
Now if this is a one-to-analog (5contatti), if I remember correctly, you need to test the cable that carries the 5V, then the tester on the cable ground and the other on the 5V, and verify that it has not too many oscillations (+0.1 V if I'm not mistaken).
The second point to be checked the cable that leads 1V (egnale air mass), and even here it must be checked if the voltage does not deviate too much from the nominal voltage (+-0,1).
If the values are too low mean that ? busted. I'm at the point to be changed.
If it is a digital speech change (4 contacts) , you normally do not ever breaks, but you can get dirty and should be cleaned up.
I hope I remembered everything and she said crap.
2014062922230600.jpg
this is my... this is digital,in order to control it?
xathanatosx where to watch cn multiecuscan??
well ? more complicated, on this is missing the contact of 5V, but remains that of the air temperature, the 12V, the mass, unchanged from the analog, and c'? the signal mass air intake.
But to be able to measure this, if I remember correctly, it takes an oscilloscope (I informed a short time ago)
Anyway ec difference between bosh and pierburg have frequency differences of the work,the mass air flow sensor bosch generates a signal with a frequency that increases with the increase of the
air mass, while the deb. pierburg drops with Frequency.
Ps. I can't see the images
with multiecuscan no one can see anything? I l oscilloscope ec l I...
Click on parameters and scroll down to search for the items air Mass measured Mass air objective (and temp air).
You have done this you make a turn by activating the chart. If you do not make monsters values should be as similar as possible. well, in my opinion, check the voltages.
Write permission
Quote