E.g. the ecu locked and ripristno bdm info

[klajdin]

in 1.3 the reading from the serial port and of 448kb and not you can write it down in the bdm, why? the complete file, and 2mb

Not ? that's right, this depends on the HW, and then by the type of memory that has inside of it, on 1.3 you are out of a file of 2.5 mb.

[tecnoracing]

you are doing a bit of confusion the file from 448kb the laws marelli 70 hp on 75 -90 hp read 2 mb then it depends on the type of tool that you use such as about 70 hp, you can read 449kb 452 also 64kb I repeat, depends on the tool

in 1.3 the reading from the serial port and of 448kb and not you can write it down in the bdm, why? the complete file, and 2mb

[ema74]

I meant on the classic 6f3, 70 hp read with magpro

[sportknight]

I spoke of the 75... reading in the serial is good even in the bdm,just delete the zone, mpc...

[pesceautoservice]

anyway, from what I know, without fasciarsi the head, just that is a full backup the same hw and sw, is a partial e2p, recoding the injectors and then it should be ok. To me ? happened to pi? times with mpps on 6f3 s4, also writing in recovery,and I solved in this way.I have the problem to rebuild the flash, why? I don't know where to start, I still have all this practicality

[ema74]

on 6f3 it seems strange to me that ricodifichi injectors

[ema74]

in fact, I've specified in the 6f3 70 hp read with magpro is outside the file from 448.
tecnoracing but the 75 and 90 6f3 and 8df which instrument you read them in serial?
perhaps kess v2

[tecnoracing]

should I read them both with kess v2 with the chicken v53

[tecnoracing]

of course, the virtual read with the chicken

[tecnoracing]

About 70 bhp ecu ? the 6jf and read out in serial from a file to 448-kB on 75/90 hp the ecu ? the 6f3 or 8fxx, and read out in serial from a file that is 2.5 MB, and bdm from the files of the flash m58bw016 2048 KB ir? the files of the micro 516 KB, and the file of eeprom, 4KB.


If the ecu ? a 6f3 or 8fxx and the k-line wired you can read it in serial, and the bed can? be written in the bdm (the reading takes a lot);
if you do not have the k-line wired and you have the galletto 2, f? the virtual read, i.e. if the cel has in its database d? the file directly without reading anything.


Different speech for the edc16, serial always read the file from 2 MB, but contains only the tables of the maps, not all of the content of the flash, so you can't write it with the bdm.



Be careful to write 6f3 with galletto 1260 or mpps, often hangs at 50% and plane of the eeprom.

the exact quote was reasonable matthew