Reading tour IAW59F with FGTechv53

[Rebound]

fgtech v53 can read/write via serial to obd ?
the bench does not succeed...

[chicco]

in the tour you must read if the interface works, the problem ? only in the epilogue to the tour if not ? virgin, I have tried both with the ecu under and over the 100.

[motorsport]

if, and under 100 serves a dedicated interface!!

[chicco]

under the 100 serves a dedicated interface to make it a virgin but not to read it, I made one last week to tour, read, coded and it can be programmed in the
scodificata with the proper tool and then programmed, I have the special tool to do these jobs but I wanted to try the cock with both ecu under and over the 100 to test reading and writing.

[motorsport]

I understood for scodifica )

[giuseppe1374]

to read there are problems with the cock, the laws both above and below the 100 the file ? good for mapping, but to write it, I write on the machine, or must be a virgin, for riverginarla under 100 only with tool, above 100 or tool or in the boot strap even with the cock with utility fiat clone, decode,

[Rebound]

to read there are problems with the cock, the laws both above and below the 100 the file ? good for mapping, but to write it, I write on the machine, or must be a virgin, for riverginarla under 100 only with tool, above 100 or tool or in the boot strap even with the cock with utility fiat clone, decode,

by mounting the ecu on the car, I can write it with his dump made the virgin with the dedicated software?

[chicco]

on the machine itself ? the ecu of that car you don't need to make it a virgin.

[carlo abarth]

in fact, because it already has read the code and gives you the consent to read!!

[Rebound]

then with fgtechv53 not c'? so do write to this ecu...