HELP!!!! scodifica total alfa 145 1400 twind spark ecu bosch m1.5.5

[giuseppe1374]

if you use the schema of the rooster remember that you have to have the mass in common between gallo power supply and the ecu you have done so? unfortunately, without information, there is little

[street racers]

I checked and rechecked but nothing.......if you dont connect it to the masses and support the thread of the boot on the pin under the cover nothing nn ago, data writing..........I don't know boooooo

[street racers]

sorry, I put the schema of the rooster!! ec who by connecting only the sti wires and was able to put it in the boot and write??? thanks!!!

[blackwolf76]

? the pattern that I used, only that I reprogrammed without opening it and without putting it in the boot. Try to write as if I wanted to get her in the serial.

[street racers]

if you use the schema of the rooster remember that you have to have the mass in common between gallo power supply and the ecu you have done so? unfortunately, without information, there is little

I have connected one of the black wires of the mass that comes out from the cock to the casing of the ecu and put it in the boot I used was white.......I wrong???

[aldinik]

? the pattern that I used, only that I reprogrammed without opening it and without putting it in the boot. Try to write as if I wanted to get her in the serial.

It seems strange to me from what I have said the m 1.5.5 they only make them in boot mode and on the bench.

[street racers]

rag? I'm up to the leaders nothing more anyway thanks to all for your interest!!!! we hope that it is resolved!!! have your say

[giuseppe1374]

you do not solve ever since? even when one gives you the advice you make your own! explain to me then what the center of the wire boot to the edc17? who said to use that wire??
you put the mass in common between the rooster and the ecu as I told you? if you are on your own as you want to solve??

[street racers]

Not that I have done my own head, that the test with the wire of the boot is made before you tell me how to connect.......anyway, AS I UNDERSTAND I have to connect the mass of the rooster box ecu and from the box to the pin under the cover right??? I thank you dell for help but I pissed if sometimes no I understand.....I am a novice!!!

[giuseppe1374]

here you do not upset anyone, but it seems to me that I have tried more? times as you have to do, and after two days you are still at the starting point, you need to have the mass in common
okay as you wrote above, when you put it in the boot, you notice it because you must not display in the "ID" (in km) and date programming, roughly like this:
Bosch HW: 0261204943
Bosch SW: 1037352268
Fiat HW: 1037352268
The ECU is not encoded
Max KM: 0.00 km
Date progr.: 00-00-0000
Max Revs:0
Programming: 0
Crc Errors: 0