Here are the files
Here are the files
To me it does not find the driver with the one nor with the other. I compared the file with the comparator are identical. In addition, the ecm in the info of the file it does not detect the type of power units, it hw, it sw. According to me c'? some problem in reading.
A moment that control, I would not have put the two files the same. That program uses to compare 2 files?
In fact, I was wrong. those file attachments before they were both beds with bdm 100.
This that I enclose ? read with galletto and ? working.
The file read with BDM not ? been read correctly. Use the bed with the cock that ? the correct one.
I have another flie always read with galletto and also for this ecm will not find me the driver. You may controllarmelo??
? a file of a jeep that I think has been modified.IMG_3923.jpg
This ? the flash that me is not recognized by the dcm. In the previous post I have attached the photos of the ecu .
As a gi? said if ? gi? changed the ecm not will? never the driver.
Help me to understand one thing, on the label of the ecu c'? written AUTHORIZED SOFTWARE UPDATE. If ? been updated in a jeep, the ecm also in this case, I do not find the driver?
I think that with a software update official you go to change the number software. Accordingly, if the ecm has in the database, the new driver for those codes hw and sw, recognizes him. Otherwise it is not. I'm not 100% sure, but I think it is cosOriginally Written by ecucilacunta
Write permission
Quote