Slight vibration after the map

[Exside81]

It's probably due to some increase of the map, and also happened to me, and the vibration was in the flywheel and try to put the ori, and see if it still does.
So you can look for the problem from another side

[elio]

But how can I read ORI and MOD the ecu? Available I only have the cable for the diagnosis. I can do it or not? Coma advise me and how? Thanks

[elio]

The vibration nn I feel if I change in rpm "quiet". It begins to feel if I let hit the accelerator after the 3200-3500 in the third, fourth and fifth. Aggiugo that about 130-140 if poggio your foot on the clutch, I can feel a vibration. If the poggio machine to a minimum the vibration is barely noticeable with a frequency similar to that of the rumbling engine. For the speech made instead of the machine climbs well as spins, no there are no holes or stuff like that but it seems as it is held in the progression. The engine goes up to limiter but without botta. To

[msport (exil77grande)]

to read the file, so you need a programmer type gallo v2 that have in the section on-line shop you can't do it with the diagnosis and I am sure that 99% of the map.

[fabry]

If I'm not mistake? the bimassa are mounted just above the 100 hp right ?

Hello ,no the mounts also the 90hp focus

[Exside81]

Being that he does release the pedal I don't know,unless the car, and too increased and the bimassa if it is going to without feeling live the type of vibration and a little difficult.
I ask you one thing that I can cemtrare nothing.X if you have canbiato the dishi brake?

[leandro89]

Hello check the damper torque (the leg below the transmission), because often by the time you consume the support in the rubber and tends to vibrate the car during acceleration,but if you vibrate the engine even at idle then ? check the flywheel (dual mass). Hello

also check the engine mount