guys a small update on the wg on the turbine does not work, or rather the diaphragm holds the vacuum given with the hand pump, but the stick does not walk
guys a small update on the wg on the turbine does not work, or rather the diaphragm holds the vacuum given with the hand pump, but the stick does not walk
try to spray a lot of wd40 on the lever of the wg (where it enters into the turbine practically) and it should unlock. sometimes the rust makes some jokeOriginally Written by Giuseppe2016
first thing's first, I correct what I said this type of wg will not work with the vacuum but with the pressure of the turbo itself, but it is always locked now I try with a little wd-40 will update
I imagined it was pressure and not vacuum, the last one I can only find 90 or 95 hp that have variable geometry...
Probably due to the geometry locked
if it is 75 not the geometry
first thing's first, I correct what I said this type of wg will not work with the vacuum but with the pressure of the turbo itself, but it is always locked now I try with a little wd-40 will update
I unlocked the wg but nothing pressure turbocharger remains firm on 900 mbar on the nut intake there is a tube that should open the wg, but does not exit its air of not even picking up
bad, very bad!! unmount the fan and check it out good
The wg is the pressure, in fact, has the tube running from the group, the cold of the turbo and goes to the wg which opens when it reaches that pressure, but does not exit the air from the tube I if l kill
Write permission
Quote
