Page 2 of 2 PrimaBefore 12
Results 11 to 14 of 14
  1. #11
    THE AVERAGE USER (OF)
    Date Of Registration
    Jul 2012
    Messages
    935
    When the sensor loses the signal, the ecu detects the engine is off, and then you enable the immobilizer for the new ignition.

    Assuming that those have made me suffer not a little of the council first of all check the sensor of turns as said above, and then go to the fuse holders in the front, on the opposite side to the ecu and the engine, smontala from its housing and clean it well. Usually fills up with moisture and create the type of problem.

  2. #12
    THE AVERAGE USER
    Date Of Registration
    Aug 2016
    Messages
    207
    Right there I thought!.....I agree!!

  3. #13
    BEGINNER
    Date Of Registration
    Jun 2016
    Messages
    74
    Thanks to all for the valuable information , unfortunately it will remain a mystery because the customer I described the problem over the phone, but for problems of costs due to the displacement of the half was stopped on the highway decided to repair to the nearest garage for the tow truck....if I have news I will communicate no less than thanks a lot to all

  4. #14
    BEGINNER
    Date Of Registration
    Jan 2017
    Messages
    6
    It shuts off at full load to partial load or minimum first

Page 2 of 2 PrimaBefore 12

Tags for This Discussion

Write permission

  • You you can not post new threads
  • You you can not send answers
  • You you can not send attachments
  • You you can not edit your posts
  •