Build obd female-to-read-the-counter.

[riox80]

I do not speak of mjd6f I speak for the ecu that can be read in via the boot.

[cinqueturbo]

I do not speak of mjd6f I speak for the ecu that can be read in via the boot.

"Now persupponiamo need to connect a mpps which can be supplied from the power supply I should look for the + in the entry and also the link to swich to the framework...today we work on...my goal is to prepare them directly to the original cable that mounts on the ecu. I will do the first, the most common of the former mjd6...."

six er top..

[riox80]

20161029_144532.jpgWill is a future tense...means that after that, I realized that you can do in the boot does not do that. In fact, it was an example. Now give me a clear explanation to this photo

[CLAUDIO.]

Riox80 you're doing quite a bit of confusion. that centa.reading the serial pinout with the one in bootmode ? Serial , boot , bdm are a diverza from the other .

[riox80]

For your convenience, I have reproduced a cable tricore in obd2, which will then be linked to the original cable control units the most common that you can do in the boot mode.20161029_162333.jpg

[riox80]

Zero-cost.

[cinqueturbo]

20161029_144532.jpgWill is a future tense...means that after that, I realized that you can do in the boot does not do that. In fact, it was an example. Now give me a clear explanation to this photo

You know that link,but if you can read this make me a whistle, 99% even official tools fail us by returning the message to read it in BDM.
Then I don't see The utility in it's Practicality reading, however, would be Partial, read-out times exaggerated

Zero-cost.

even here I can see what you have invented so wonderful since you already have the original cable for that type of work..
I have recommended to take the sockets that you need for the different types of ecu and create a wiring harness for plug&play to speed up the work
WP_20161029_18_18_50_Pro.jpg

[Errecinque]

20161029_144532.jpgWill is a future tense...means that after that, I realized that you can do in the boot does not do that. In fact, it was an example. Now give me a clear explanation to this photo

The clear explanation is that if I'm not mistaken that link is used to read in bdm the marelli 6jf/6f3 opening them, and by connecting to the port dedicated his first resistance. It's not as if the reading from the obd

[riox80]

Here are the photos

[riox80]

You will not believe it, but with my much-discussed cable I used mpps to tour with reading boot mode...cool....do you think that the cock is unable to read this edc 15p+ to the bench with the boot. Perfect File 512kb. Between some place the photos.