change advances

[cicciogsr]

and ends thirty degrees in the morning?

[Chris156]

nooo...

[cicciogsr]

the file that I posted I the injection lasts 30? to 70 sq mm and the advance ? of 20 degrees for the same amount?.. eye 30 to which I am not ? advance..

[cicciogsr]

the two degrees on the basis of what you have calculated?

[Chris156]

take care to give degrees to.....

[megamind]

I have not done that calculation, I lifted the times up to 7%, and knowing that the limiter is at 40 degrees I raised the advances. Following the ori. But I am the beginning and I did this test because I think that when you do a mod. Increases or decreases in all of the maps that are in the report. For me it is difficult to think that the person who made the original map I did wrong. Then I try to raise following the set in the set where I need it.

[cicciogsr]

I have not done that calculation, I lifted the times up to 7%, and knowing that the limiter is at 40 degrees I raised the advances. Following the ori. But I am the beginning and I did this test because I think that when you do a mod. Increases or decreases in all of the maps that are in the report. For me it is difficult to think that the person who made the original map I did wrong. Then I try to raise following the set in the set where I need it.

as the beginning of v? well to understand how it all works.. and according to me, you'll realize that the advance arrived at a certain point, you do not need to touch it..

[savek]

I support my thesis cio? if you just leave them original

[munro]

guys who's? the formula to calculate, or better to convert the microseconds in degrees crankshaft?
let me explain, if I have for example an injector which opens to 594 microseconds how can I quantify how many degrees of rotation the motor match?

[franco75]

Degrees=rev/min*6*T
Es: 584 µsec at 3000 rpm
Degrees = 3000*6*584/1000000 = 10.5 degrees