Audi 2.0tsi 200cv increase in pump flow

[simone82]

Tomorrow I try with my own and I'll post the log

[cawadany]

look at the log...
cawadany runs fine now

I have a file from fear!
And considered to that log ? 3a. In the 4th he probably would have loaded a p? pi? pressure.

[simone82]

To replace the pump ? a complicated procedure?

[polini]

I have a file from fear!
And considered to that log ? 3a. In the 4th he probably would have loaded a p? pi? pressure.

in general we consider the values of IV

To replace the pump ? a complicated procedure?

nonsense

there are three pins, two tubes and two pins

[simone82]

Just give up the torx screws and pull it out without having to do any special procedure

[cawadany]

in general we consider the values of IV

But often not ? simple take advantage of all of the 4a. And the 3rd logged with mode? turbo by quite a bit of values.

[polini]

gi? that upgrading also changes the glass (06D 109 309C)

But often not ? simple take advantage of all of the 4a. And the 3rd logged with mode? turbo by quite a bit of values.

I prefer the mode? with the traditional IV
I could also, like you do you are unable to interpret

by simon that we can't....

Just give up the torx screws and pull it out without having to do any special procedure

you're just careful when heading up to load the spring centered perfectly in the glass

[simone82]

The glass can not find it on the new pump?

[polini]

I don't think there is

[simone82]

I found the new 200€ on ebay