EDC16C - impariamola!

[mariodarkblue]

I thought the revs were limited by the advances that, in fact, at 5000 rpm are high, according to me, postponing a while you may overcome them, also try to redo all the break point where there is a lack laps

Uhm..no..by the advances no...to the maximum should read the same degrees of advance, even after the 5000giri...I redid the bp of the lim pair of first gear...but I think there is another...

[tidus1985]

try to redo the bp of the map conversion torque diesel over 5000 rpm, after various tests that ? one of the few maps that do not fit in the axis couple in axis revolutions

[mariodarkblue]

try to redo the bp of the map conversion torque diesel over 5000 rpm, after various tests that ? one of the few maps that do not fit in the axis couple in axis revolutions

Uhm...I have to try and do as you say...I have to try the mod to the bp of the lim torque of the first gear....even if I told you, patrick...I feel like there is a few bits that limits you to 5000...mmm....and then there are a couple of corners before the lim gear to gear that I don't understand what's the use..

[tidus1985]

by damos do not see it?

[SandroMarciano]

today I gave a look on the damos, but do not appear-bit and limited to 5000, just someone to 6000 and one related to the cruise at 4500

[tidus1985]

I would like to know if all the edc16c39 have in pinout to the button sport on the 147 ducati corse

[SandroMarciano]

It is said of you, I also have a PDF of how to mount it aftermarket

[msport (exil77grande)]

It is said of you, I also have a PDF of how to mount it aftermarket

could you post it?

[SandroMarciano]

Of course, now with the cell, as soon as I connect to the PC the place without any problems!

[msport (exil77grande)]

Of course, now with the cell, as soon as I connect to the PC the place without any problems!

but you have the 147? 've never tested this pin out?